Module Information; Viewing I/O And Diagnostic Information - Emerson FloBoss 107 User Manual

3.5 Module Information

3.5.1
Issued Sep-07
: You can edit the orifice diameter value. These parameter
Note
screens remain active for 30 minutes, after which the
Touchpad displays the idle state screen.
4. Touch Exit to display the Plate Change menu screen.
5. Touch Exit to display the Meter menu.
Touch Exit to display the Meter Run menu.
6.
Use this option to view information for each module installed in the
FB107. The Modules menu shows only the modules you have installed
on your FB107. For example, Figure 3-25 shows a fully equipped FB107
with expansion plate. If your FB107 has an open module slot, the
Touchpad shows the slot number but does not include a module
identifier. If your FB107 does not have an expansion plate, the Touchpad
displays the second row (slots 4 through 7) but omits the numbers,
indicating those slots are not available.
You can also use this menu to display information on meter runs (refer to
Section 3.5.5, Viewing Meter Information) and to diagnose alarm
conditions (refer to Section 3.5.8, Calibrating a Point).

Viewing I/O and Diagnostic Information

1. Touch Modules on the Main Menu. The Modules menu displays.
:
Notes
A blinking asterisk (*) in the upper right corner of a module box
(as in slots 0 and 3 in Figure 3-25) indicates an integrity or alarm
issue in this module. This mirrors a blinking asterisk that may
appear in the upper right corner of the Modules option on the
Main Menu.
The content of the Modules menu corresponds to your installed
system. The example in Figure 3-25 shows a fully loaded FB107.
Using the Touchpad
Figure 3-25. Modules Menu
FB107 LCD User Manual
3-15