Cisco Catalyst 3550 Installation Manual page 77

Chapter 2 Installing and Starting the Switch
Figure 2-24 Stripping the Ground Wire
Slide the open end of the ground lug over the exposed area of the 6-gauge wire.
Step 3
Step 4 Using a Panduit crimping tool, crimp the ground lug to the 6-gauge wire, as shown
in
Figure 2-25 Crimping the Ground Lug
Step 5 Use the two number-10-32 screws to attach the ground lug and wire assembly to
the switch rear panel RPS connector, as shown in
Step 6 Using a ratcheting torque screwdriver, torque each ground-lug screw to 15 lbf-in.
(240 ozf-in.)
78-11358-03
0.5 in. (12.7 mm) ± 0.02 in. (0.5 mm)
Insulation
Figure 2-25.
Catalyst 3550 Multilayer Switch Hardware Installation Guide
Connecting to DC Power
Wire lead
Figure 2-26.
2-27