Care And Cleaning - Catler 400 Series Instruction Manual

CARE AND CLEANING

Before disassembling and cleaning, release
the main switch. Wait until it completely
stops and remove the power cord plug from
the power outlet.
Do not use any alkaline or abrasive cleaning
agents, steel wool or sponges with steel wool,
petrol, dissolving agents or any other similar
agents for cleaning the appliance as these
could damage the surface.
Cleaning the motor unit
To remove any food residue wipe the motor
unit and cord with a damp cloth only.
Cleaning the blending attachment
After deattaching the blending attachment,
it can be hand washed in hot soapy water,
rinsed and dried thoroughly. Alternatively,
the blending attachment can also be washed
in the dishwasher.
Before re-attaching, ensure there is no water
residue left inside the attachment.
NEVER IMMERSE THE MOTOR UNIT IN WATER OR ANY OTHER LIQUID. DO NOT
PLACE MOTOR UNIT IN THE DISHWASHER.
BLADES ARE VERY SHARP. PAY YOUR OWN ATTENTION WHEN HANDLING
BLADES.
Quick wash: Between each processing task,
with the motor unit attached and turned
on at the power outlet, place the blending
attachment only into a jug of water and press
the main switch to turn on for 5 seconds.
This will remove any food on the blade and
leg and allow you to continue onto the next
processing task.
Cleaning the chopper bowl, chopper bowl
lid with gear, chopping blade and lid /
NOTE
anti-slip mat
After disassembling the chopper, the chopper
bowl, chopper bowl lid with gear and chopping
blade should be hand washed in hot soapy
water, rinsed and dried thoroughly. Accessories
(chopper bowl, chopping blade and lid / anti-
slip mat) can be also washed in the diswasher.
Do not wash the chopper bowl lid with gear in
the dishwasher.
Before re-assembling, ensure there is no water
residue left inside the attachment.
15
CARE AND CLEANING