Ext Comm Module - ABB ACS355 User Manual

276 Actual signals and parameters
All parameters
No. Name/Value
51 EXT COMM
MODULE
5101 FBA TYPE
NOT DEFINED Fieldbus module is not found, or it is not properly
PROFIBUS-DP Profibus adapter module
CANopen
DEVICENET
5102 FB PAR 2
... ...
5126 FB PAR 26
5127 FBA PAR
REFRESH
DONE
REFRESH
5128 FILE CPI FW
REV
0000...FFFF
hex
5129 FILE CONFIG
ID
0...65535
5130 FILE CONFIG
REV
0...65535
5131 FBA STATUS
IDLE
EXECUT INIT
Description
The parameters need to be adjusted only when a fieldbus
adapter module (optional) is installed and activated by
parameter 9802 COMM PROT
parameters, refer to the manual of the fieldbus module and
chapter Fieldbus control with fieldbus adapter
These parameter settings will remain the same even though
the macro is changed.
Note: In adapter module the parameter group number is 1.
Displays the type of the connected fieldbus adapter module.
connected, or parameter
not EXT FBA.
CANopen adapter module
DeviceNet adapter module
These parameters are adapter module-specific. For more
information, see the module manual. Note that not all of
these parameters are necessarily visible.
Validates any changed adapter module configuration
parameter settings. After refreshing, the value reverts
automatically to DONE.
Refreshing done
Refreshing
Displays the parameter table revision of the fieldbus adapter
module mapping file stored in the memory of the drive.
Format is xyz where:
• x = major revision number
• y = minor revision number
• x = correction letter.
Parameter table revision
Displays the drive type code of the fieldbus adapter module
mapping file stored in the memory of the drive.
Drive type code of fieldbus adapter module mapping file
Displays the fieldbus adapter module mapping file revision
stored in the memory of the drive in decimal format.
Example: 1 = revision 1.
Mapping file revision
Displays the status of the fieldbus adapter module
communication.
Adapter is not configured.
Adapter is initializing.
SEL. For more details on the
9802 COMM PROT SEL
Def/FbEq
on page 325.
0
setting is
1
32
37
0
1
1 = 1
1 = 1
1 = 1
0
1