Power Connector Cable - HP Envy 17 Series Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
7. Remove the system board (see
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Release the power connector cable from the clips (2) and routing channel built into the keyboard/
top cover.
3. Release the power connector (3) from the molded slot built into the keyboard/top cover.
4. Remove the power connector cable.
Reverse this procedure to install the power connector cable.
Battery on page 24).
Optical drive on page
Bottom cover on page
System board on page
25).
28).
40).
Component replacement procedures
HP Confidential
Spare part number
809295-001
49