5.
Lift the rear edge of the TouchPad and the rear bracket, and then remove them (3).
NOTE:
is installed under the keyboard shield (4).
Reverse this procedure to install the TouchPad.
Display assembly
Before removing the display assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the optical drive (see
6.
Remove the bottom cover (see
Remove the display assembly:
1.
Remove the four Phillips PM2.5×5.0 screws (1) that secure the display assembly to the computer.
2.
Rotate the display hinges (2) back to the fully released position.
When installing the TouchPad, note that the metal protrusion that extends from the TouchPad
Battery on page
Optical drive on page
Bottom cover on page
24).
25).
28).
Component replacement procedures
HP Confidential
51