Troubleshooting - Haier HD80-A82 User Manual

TROUBLESHOOTING

Before contacting the customer service, please check the following cir-
cumstances:
PROBLEM CAUSES
–
Tumble dryer
fails to operate.
–
–
–
–
–
–
Tumble dryer
fails to operate
and the display
–
shows END.
–
Drying time is
too long and
–
the results are
–
not satisfac-
–
tory.
–
–
Remaining time The remaining time will be
on the display adjusted continuously based
stops or skips. upon the following factors:
–
–
–
–
Poor connection to the
power supply.
Power failure.
No drying program is set.
Device has not been
switched on.
The water tank is full.
The door is not closed
properly.
The laundry has reached
the condition defined by
the program.
There is no laundry in the
drum.
The program setting is not
correct.
The filter is clogged.
The evaporator is blocked.
The tumble dryer is over-
loaded.
The laundry is too wet.
The vent duct is blocked.
Type of laundy.
Loaded amount.
Moisture degree of the
laundry.
Ambient temperature.
SOLUTIONS
∙
Check connection to the
power supply.
∙
Check the power supply.
∙
Set a drying program.
∙
Switch the device on.
∙
Empty the water tank.
∙
Close the door properly.
∙
Check if the program setting is
appropriate.
∙
Check if there is laundry in the
drum.
∙
Make sure the program is set
correctly.
∙
Clean the filter screen.
∙
Clean the evaporator.
∙
Reduce the amount of laundry.
∙
Spin the laundry properly
before drying.
∙
Check the vent duct and
unblock it.
The automatic adjustment is a
normal operation.
English | 17