Adjusting The Steer; Cleaning The Tiller; Maintaining The Chain Housing; Engine - Texas Equipment Vision 700 NC Assembly And Use Instructions

The depth skid can be adjusted to suit various tilling depths. The deeper into the ground
the depth skid goes, the deeper the tiller will work. The right setting depends on the ground
conditions.
Figure F/G.

Adjusting the steer

The height and angle of the steer can be adjusted. It can be an advantage to adjust the
steer to either left or right during cultivating. Then you can avoid walking in the cultivated
soil. Use the wheel figure J, 1.

Cleaning the tiller

The tiller should be cleaned after use. Use a garden hose to wash off soil and dirt.
Remove any grass, etc. from the rotor shaft. The chassis number should only be cleaned
with a damp cloth, otherwise there is a risk that it might be erased. Avoid using a high-
pressure washer during cleaning.

Maintaining the chain housing

The chain housing is lubricated with TEXACO Multifak EP0 grease at the factory. This
process does not need to be repeated.

Engine

For correct use and maintenance of the engine, consult the accompanying engine manual.
Your machine is delivered assembled and has been test-started at the factory.
However, for safety's sake you should check the engine for oil before starting it.

Storage

If the machine is likely to be stored unused for prolonged periods, follow the instructions
below. This will ensure the machine has a long service life.
Use a garden hose to wash off soil and dirt. Remove any grass, etc. from the rotor shaft.
The chassis number should only be cleaned with a damp cloth, otherwise there is a risk
that it might be erased. Avoid using a high-pressure washer during cleaning.
Wipe the tiller over with a damp cloth so that all surfaces are clean. Wipe the surfaces
down with an oily cloth to prevent rust.
You should always store your machine in a dry, clean place.
12