HP ProLiant SL165s G7 Software Configuration Manual page 24

Figure 18 Remote Access Configuration submenu (2)
Table 16
Remote Access Configuration submenu fields (2)
Field Description
BIOS Serial Console Set this value to allow you to select 115200 as the Baud Rate
Baud Rate (transmitted bits per second) of the serial port.
Set this value to allow you to select 57600 as the Baud Rate
(transmitted bits per second) of the serial port.
Set this value to allow you to select 19200 as the Baud Rate
(transmitted bits per second) of the serial port.
Default, Set this value to allow you to select 9600 as the Baud Rate
(transmitted bits per second) of the serial port.
Flow Control Set this value to not allow Flow Control. This item disappears when
Remote Access is disabled. This is the default setting.
Select this value to make Flow Control by Hardware. This item
disappears when Remote Access is disabled.
Select this value to make Flow Control by Software. This item
disappears when Remote Access is disabled.
Redirection After Set this value to turn off the redirection after POST.
BIOS POST
Set this value to always active the redirection during POST and during
Boot Loader.
Redirection is always active (some OSes may not work if set to
Always). This is the default setting.
Terminal Type Select the target Terminal Type to ANSI. This item disappears when
Remote Access is disabled. This is the default setting.
Options
115200 8,n,1
57600 8,n,1
19200 8,n,1
09600 8,n,1
None
Hardware
Software
Disabled
Boot Loader
Always
ANSI
System BIOS configuration 24