To Use
FLASH MEASURE OF SEPARATE FLASH UNIT
You can measure the effect of an attached flash unit (with PC
connected flash units and SCA3902 compatible flash units
set to M mode), where the camera acts as a flash meter. The
aperture setting can be adjusted and more trial exposures made
until the information on the grip display is satisfactory.
To use Flash Measure:
1 Assign a button as Flash Measure button in Camera Settings
> Custom Buttons.
2 Press the Assigned button to access the flash option screen.
3 Make preliminary required aperture setting by turning the
front control wheel.
4 Press the AE-L button. The camera closes the aperture, raise
the mirror and fire the flash. Light reflected from the flash lit
subject is reflected off a white spot on the auxiliary shutter
to the meter sensor.
5 Deviations from a normal exposure are displayed as
differences in EV on the grip display and the viewfinder
display. If "High" or "Low" appears, change the aperture
accordingly and make a new test reading.
Change the aperture until Diff EV: 0 appears, or the desired
amount of deviation from the normal exposure.
Diff EV
Low = more than 2 EV below.
Diff EV
High = more than 2 EV above.
Note!
The "Low Flash" warning can be disabled in Camera Settings >
Exposure > Flash - Low Flash Warning.
H6D
USER GUIDE
Exposure Settings Menu
CAMERA SETTINGS:
EXPOSURE
Increment Step Size
Exposure:
1/2 step
Exposure Adjust:
1/3 step
Exposure Mode
Spot Mode:
Normal
True Exposure:
Flash
Low Flash Warning:
Sync:
Normal
Exposure Lock
Flash Ready:
Lens:
Out of Range:
Mirror
Extra Mirror Delay:
None
Always Return Mirror:
Image Orientation
Orientation:
Auto
www.hasselblad.com
94