Recording From Radio; Usb Operations; Erase Protection - Hyundai H-1424 Instruction Manual

Instruction manual
Cassette recording
Insert a blank cassette with the tape-side
up. Close the cassette compartment. The unit
is now ready to start recording, which can be
done from either the radio or CD.

Recording from radio

• Set FUNCTION switch to RADIO position.
• Select a band and tune to the desired
station by pressing NEXT/TUNE-UP or BACK/
TUNE-DOWN buttons.
• Press button and
simultaneously to start recording.
Recording from CD
• Set FUNCTION switch to CD position.
• Press and buttons at the same time to
start recording, then press
• Start the CD and select a song to be
recorded.
• Release button to start recording.

USB operations

• This unit is equipped with a USB socket
which can accept and play MP3 files stored
on standard USB flash (compatible with USB
version 1.1 & 2.0) up to 4 Gbs.
• To use USB drives for MP3 playback insert
the USB drive into the appropriate socket and
press STOP/CD/USB/FM MODE button on the
unit or CD/USB button on the RC.
• If MP3 files are found the set will start
playback of the first file.
• Playback control is same as for discs.
Always switch off the unit or change
mode to "CD" or "RADIO" before removing a
USB flash drive.
Attention: Although this product is fully
compatible with USB 1.1 & 2.0 standard
formats, a small percentage of USB flash
drives might not be readable, due to those
device manufacturers' non-compliance with the
full (official) USB standards.
6
provides a powerful enhancement to low
frequency music, giving a stronger bass sound
which is ideal for "rock" or "jazz" music.
set BASS BOOST switch into "On" position for
an emphasized bass sound.
button
discharged batteries should be replaced. If the
unit is not going to be used for some time or is
being run exclusively on the alternative power,
remove the batteries to avoid leakage and
button.
damage.
never be subjected to moisture or extreme
temperatures.
be exposed to water, moisture and dust.
cloth dampened with water only (be sure the
AC power cord is disconnected from the power
supply).
contact with the moving tape. Use a small
cotton bud with alcohol or special tape head
cleaner to clean these parts. Never touch the
heads with anything metallic.
edge of the disc, never touch the surface of the
disc, it would scratch the disc surface and may
occur sound distortion or raise reading problem.
cassette, simply break off the two plastic tabs
located on the cassette tape's rear side.
tabs is inserted, the recording button cannot be
pressed.
Dynamic bass boost system
• The built in "super bass booster" circuit
• For increased bass at all volume levels,
Maintenance and care
• Check your batteries regularly, old or
• Electronic products of this kind should
• Do not use the unit in places where it can
• If necessary, clean the unit with a piece of
• The heads and capstan are in constant
• When pick up the CD disc, always hold the

Erase protection

• To prevent accidental erasing of a
• When a cassette with removed plastic
• If a cassette is to be erased and re-