Hyundai H-1424 Instruction Manual page 4

Instruction manual
Radio operation
• Set FUNCTION switch to RADIO position.
• Select your desired broadcasting band by
pressing PLAY/BAND(AM/FM) button.
• Press NEXT/TUNE-UP button or NEXT/
TUNE-UP button and then release the button
when the fast scanning starts. The frequency
will continue to change and will automatically
stop when a broadcast station is received.
• To receive a weak broadcast signal press
the NEXT/TUNE-UP or NEXT/TUNE-UP
button by one press at a time and adjust the
frequency you wish to receive.
Radio station memory
• 12 broadcast stations: 6 FM band and 6 AM
stations can be stored to the preset memory.
• During tuner mode, find a desired station.
• Press FOLDER/MEM.SET/SKIP+10 button
to make the channel display appear. Memory
setting mode will be activated.
• Press NEXT/TUNE-UP button or BACK/
TUNE-DOWN button to choose the desired
channel.
• Press FOLDER/MEM.SET/SKIP+10 button
again, then the desired station is stored in the
channel. The display shows the channel of the
desired station.
• Repeat the steps for storing various
stations to other channels.
Antenna
• For FM reception, adjust the telescopic
antenna appropriately to obtain the best
reception on the band selected.
• The AM signal is picked up through the
built-in ferrite antenna. The set should be
placed to a position for the best reception.
CD operation
Insertion and removal of discs
• Place a disc into the compartment with the
label-side (printed side of disc) facing upwards.
4
Press down in the center part of disc until the
disc "locks" onto the center spindle.
• When the disc has been placed onto
the center spindle, gently lower the CD-door
downwards until it locks shut. The disc is now
ready to be played.
• Press STOP/CD/USB/FM MODE button
on the unit or STOP/FM MODE button on the
RC to stop the disc spinning before opening
the CD-door.
• To remove a disc, follow the same
procedure as described above, except to
remove the disc instead of inserting it into the
compartment, by placing one finger at the
middle of disc (center spindle) and the other at
the edge of the disc and gently pulling upwards.
Always hold a disc by its edges. Avoid
getting any fingerprints, smudges or dirt onto
the surface of a disc. In case this happens, use
a special CD-cleaning cloth or cleaning kit to
remove the dirt or smudges. Please make sure
to always fold down the handle before opening
the CD door.
General operation
• Set FUNCTION switch to CD/USB (MP3)
position.
• Put a CD into the CD compartment and
close the CD door.
• The LCD display will show the total
number of track after a few second.
Play/pause mode
• Press PLAY/BAND(AM/FM) button to start
play, the LCD display will show the first track.
• Press PLAY/BAND(AM/FM) button to
pause at any track when playing, track number
on the LCD display flashed.
• To stop the CD, press STOP/CD/USB/FM
MODE button on the unit or STOP/FM MODE
button on the RC. This will reset the CD player
to the first track.
Skip and search mode
• Press NEXT/TUNE-UP button once to skip
to the next track. Keep pressing to search for
a particular at high speed forward. Release the