Fujitsu 2737 User Manual page 165

4.6.2 Mounting the rail units
Secure the rail units to the rack posts using the M5 cage nuts that were attached in step 1 and 2
according to "4.6.1 Inserting cage nuts".
1
Push the left and right disconnect springs on the slide rails to release the
lock of the table unit, and then remove the rail units from the table unit.
Rail unit
Table unit
2
Fit the rear brackets of the rail units in place on the rear posts of the rack.
Then, using the supplied M5 screws, secure them to the M5 cage nuts that
were inserted in step 1 and 2 into the rack posts (front and rear) according
to "4.6.1 Inserting cage nuts". (Eight screws)
Rack posts (rear)
Rack posts (front)
Front
 Loosen the two adjusting screws on the rear brackets to adjust the units to the
appropriate pitch between the rack posts (front and rear) on which they are
mounted. After the adjustment, fully tighten the screws.
Rail unit
Rear
Rail unit
Rail unit
M5 screw
Disconnect spring
Push in this direction
M5 screw
M5 screw securing
holes
4 Handling the Rack after Installation
M5 screw securing
holes
Part to be inserted
165
E