Venting - Heatilator GCDC60 Installation & Operating Instructions Manual

1. Conversion from Top Vent to Rear Vent
a. Remove the screw holding the heat shield cover
plate to the top of the appliance and set aside.
See Figure 5.
Note:
If the appliance is to be top vented discard this
plate and replace the screw you removed. If the
appliance is to be rear vented, continue to Step b.
Figure 5 - Insulated Cover Plate, Top of Appliance
f i r e - p a r t s . c o m
b. Remove the three remaining screws holding the
plate surrounding the flue. See Figure 6. Remove
the plate and set aside.
Figure 6 - Remove Plate Screws
c. Remove the four screws holding the inner plate
surrounding the flue. See Figure 7. Remove the
inner plate and discard.
Figure 7 - Inner Plate, Top of Appliance
8
CALIBER DIRECT VENT INSTALLATION INSTRUCTIONS
E. VENTING
d.
Figure 8 - Remove Four Screws from Outer Collar
e.
f.
30803 Rev X
Remove the four screws holding the outer collar
to the appliance top. See Figure 8. Remove the
outer collar.
Remove the four screws holding the inner collar
to the appliance top. See Figure 9. Remove the
inner collar.
Figure 9 - Remove Screws from Inner Collar
Remove the four screws holding the outer shell
cover. See Figure 10. Remove the outer shell cover
and set aside.
Figure 10 - Outer Shell Cover
08/04