Table of Contents
Advertisement
To determine whether your appliance is an intermittent
pilot ignition or a standing pilot ignition system, open
the control access panel to examine the wiring system.
If your system has a red ignitor button, as shown in
Figure 64, you own a standing pilot ignition appliance.
If no red ignitor button is present, you own an
intermittent pilot ignition appliance.
You may also check the rating label located on the
inside of the control access panel to determine ignition
type.
1. Intermittent Pilot Ignition
f i r e - p a r t s . c o m
If you do not follow these instructions exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.
A.
This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the
burner. Do not try to light the burner by hand.
B.
BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to turn the manual shutoff valve. Never use tools. If the lever or knob will not move by hand,
don't try to repair it - call a qualified service technician. Force or attempted repair may result in a fire or
explosion.
D. Do not use the appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been under
water.
1.
STOP! Read the safety information above on this label.
2.
Turn wall switch to the "OFF" position.
3.
This appliance is equipped with an ignition device which automatically lights the burner. Do not try to light
burner by hand.
4.
Wait five minutes to clear out any gas. If you then smell gas, STOP! Follow "B" in the safety information above
on this label. If you don't smell gas, go on to the next step.
5.
To turn on burner, turn on the wall switch.
6.
If the appliance will not operate, follow the instructions "TO TURN OFF GAS TO APPLIANCE" and call your
service technician or gas supplier.
1.
Turn off the wall switch.
2.
Open the control access panel.
28
CALIBER DIRECT VENT INSTALLATION INSTRUCTIONS
I. DETERMINE THE IGNITION
J. LIGHTING INSTRUCTIONS
FOR YOUR SAFETY
READ BEFORE OPERATING
WARNING!
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
3.
4.
30803 Rev X
Figure 64
Standing Pilot Ignition
Turn gas line to the "CLOSED" position. Do not force.
Close the control access panel.
08/04
Hide quick links:
Advertisement
Table of Contents
