Heatilator GCDC60 Installation & Operating Instructions Manual page 11

CALIBER DIRECT VENT INSTALLATION INSTRUCTIONS
o. Locate the outer shell cover that was removed in
Step f. Place the cover on top of the appliance.
See Figure 19. Replace the four screws that hold
this plate in place. See Figure 20.
Figure 19 - Place Cover Plate on Top of the Appliance
f i r e - p a r t s . c o m
Figure 20 - Screw Cover Plate into Place
08/04
p. The appliance should look like the one shown in
Figure 21 after it has been converted to a rear
vent appliance.
Figure 21 - Completed Conversion
30803 Rev X 11