For Your Safety - Heatilator GCDC60 Installation & Operating Instructions Manual

CALIBER DIRECT VENT INSTALLATION INSTRUCTIONS
2. Standing Pilot Ignition
If you do not follow these instructions exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.
A. This gas appliance has a manual ignition device that lights the pilot. When lighting the pilot, follow these
instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob to light the pilot. Never use tools. If the knob will not
f i r e - p a r t s . c o m
push in or turn by hand, don't try to repair it - call a qualified service technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use the appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been under
water.
STOP! READ THE SAFETY INFORMATION ABOVE ON THIS LABEL!
1. Turn wall switch to the "OFF" position.
2. Open the control access panel.
3. Turn gas line to "CLOSED". Wait 5 minutes to clear
out any gas. Then smell for gas, including near the
floor. If you smell gas, STOP! Follow "B" in the safety
information above on this label. If you don't smell
gas, go to the next step.
4. Turn gas line to "OPEN".
5. Turn pilot knob clockwise to "OFF" (knob may have
to be depressed to pass the PILOT position).
6. Locate pilot assembly inside the appliance.
7. Locate red ignitor button.
8. Turn pilot knob to "PILOT" and push in.
9. Continue to hold in pilot knob and push the red
ignitor button 12-15 times until small blue pilot flame
appears.
10. Continue to hold in pilot knob for approximately one
minute. Pilot should remain lit. If pilot goes out, wait
5 minutes and repeat Steps 4-9.
11. To light the main burner, release and turn the knob
counterclockwise to "ON". If the appliance is
connected to a wall switch, turn the switch to "ON".
Do not light by hand.
12. If the appliance will not operate, follow the
instructions "To Turn Off Gas To Appliance" and call
your service technician or gas supplier.
08/04

FOR YOUR SAFETY

READ BEFORE OPERATING
WARNING!
LIGHTING INSTRUCTIONS
1.
2.
3.
4.
30803 Rev X
TO TURN OFF GAS TO APPLIANCE
Turn off the wall switch.
Open the control access panel.
Turn the gas line to the "CLOSED" position. Do not
force.
Close the control access panel.
29