Heatilator GCDC60 Installation & Operating Instructions Manual page 10

k. Locate the plate removed in Step b. Place the
plate around the rear vented collars and replace
the four screws that hold the plate in place. See
Figure 15.
Figure 15 - Place Insulated Plate on Rear of Appliance
f i r e - p a r t s . c o m
l. Place the inner cover plate on the appliance top
and replace the four screws that hold the inner
cover plate in place. See Figure 16.
• Make sure insulation is replaced with the
cover plate.
Figure 16 - Place Inner Cover Plate on Top of Appliance
10
CALIBER DIRECT VENT INSTALLATION INSTRUCTIONS
m. Place the outer cover plate on the appliance top
Figure 17 - Place Outer Cover Place on Top of
n.
Figure 18 - Place Heat Shield Cover Plate on Top of
30803 Rev X
and replace the four screws that hold the outer
cover plate in place. See Figure 17.
• Make sure insulation is replaced with the
cover plate.
Appliance
Locate the heat shield cover plate that was
removed in Step a. Place the cover plate on top of
the heat shield. Replace the four screws that hold
this plate in place. See Figure 18.
Heat Shield
08/04