Heatilator GCDC60 Installation & Operating Instructions Manual page 9

CALIBER DIRECT VENT INSTALLATION INSTRUCTIONS
g. Remove the four screws holding the outer cover
plate to the appliance back. See Figure 11.
Remove the outer cover.
Figure 11 - Remove Outer Cover Plate
f i r e - p a r t s . c o m
h. Remove the four screws holding the inner cover
plate to the appliance back. See Figure 12.
Remove the inner cover.
Figure 12 - Remove Inner Cover Plate
08/04
i. Place the inner collar on the appliance back and
replace the four screws that hold this collar in
place. See Figure 13.
• Make sure insulation is attached to the collar
base.
Figure 13 - Place Inner Collar on Rear of Appliance
j. Place the outer collar on the rear of the appliance
and replace the four screws that hold this collar
in place. See Figure 14.
• Make sure insulation is attached to the collar
base.
Figure 14 - Place Outer Collar on Rear of Appliance
30803 Rev X 9