Heatilator GCDC60 Installation & Operating Instructions Manual page 33

CALIBER DIRECT VENT INSTALLATION INSTRUCTIONS
4. Venting System Inspection
The appliance and venting system should be inspected before use, and at least annually, by a qualified field service
person, to ensure that the flow of combustion and ventilation air is not obstructed.
5. Cleaning the Glass
See Figure 69. Never operate this appliance without the glass properly secured in place or if the glass is broken.
In the event of glass breakage, carefully remove the glass frame. This will allow the removal of all glass fragments
and sheet metal edge protection strips. Vacuum all remaining glass pieces with a shop vac. DO NOT VACUUM IF
PIECES ARE HOT. Replace glass with only a Heatilator glass panel assembly ordered through your local distributor.
Never use substitute material. Only fully tempered soda lime safety glass or ceramic glass may be used on this
appliance.
f i r e - p a r t s . c o m
6. Log Removal/Replacement
If removal of the logs becomes necessary, remove
the two screws, one at each end of the grate. Grasp
the grate as shown and pull the logs up and off the
burner. See Figure 70.
To replace the logs, grasp the grate as shown. Lower
the log set onto the burner pan, making sure the tabs
on the front of the grate line up with the holes provided.
Attach the two screws at each end of the grate.
08/04
Figure 69 - Glass Cleaning
30803 Rev X
Safety Note:
Handle glass
with care to
avoid striking,
scratching or
slamming shut.
NEVER clean
glass when it is
h o t . K e e p
children and
pets
distance away.
Figure 70 - Log Removal
a safe
33