Venting - Heatilator CALIBER DESIGNER B-VENT SERIES Installation And Operating Instructions Manual

1. Vertical Termination
Note:
This appliance is designed and tested for
use with a listed 5-inch B-Vent system.
downsize pipe.
Vent clearances are per vent manufacturer’s
specifications.
Various venting configurations are shown in
Figures 4 and 5 from which maximum vent runs
can be determined.
WARNING - RISK OF FIRE!
8
E. VENTING
2. Firestop Spacer/Vent Installation
Frame an opening and install a firestop spacer
whenever the vent penetrates a ceiling/floor area, as
shown in Figure 6. Frame the opening with the same
sized lumber as used in the ceiling floor joists. Unless
the flue is offset, the hole should be directly above the
appliance. DO NOT pack insulation around the vent.
Assemble vent sections with three screws per joint.
33795 Rev i
CALIBER DESIGNER SERIES
WARNING!
CAUTION:
01/04