Lexmark S800 Series Service Manual page 28

Lexmark S800 Series
Error
Name
Code
1212 Watchdog Error
1213 Data Abort Error
1214 Invalid Processor Mode Error
1215 Math Error
1216 Mailbox Error
2-9
Service Manual
Description
Indicates printer system was
reset by Watchdog timer;
Subsystem stall failure.
Firmware attempted to load or
store to an invalid address.
Indicates the ARM processor
was in an incorrect mode to
perform the requested
operation.
There is a problem doing math,
such as dividing by zero.
Problem with the internal
mailbox messaging system.
Action
Technical Support Center:
Unplug the All-In-One from the wall outlet;
wait a few seconds, then plug the All-In-
One back in and turn the power on. If the
problem remains, then replace the USB
cable.
Service:
Replace the system board. See
board with media sensor, cable, and
spring removal" on page
Technical Support Center:
Unplug the All-In-One from the wall outlet;
wait a few seconds, then plug the All-In-
One back in and turn the power on. If the
problem remains, then replace the USB
cable.
Service:
Replace the system board. See
board with media sensor, cable, and
spring removal" on page
Technical Support Center:
Unplug the All-In-One from the wall outlet;
wait a few seconds, then plug the All-In-
One back in and turn the power on. If the
problem remains, then replace the USB
cable.
Service:
Replace the system board. See
board with media sensor, cable, and
spring removal" on page
Technical Support Center:
Unplug the All-In-One from the wall outlet;
wait a few seconds, then plug the All-In-
One back in and turn the power on. If the
problem remains, then replace the USB
cable.
Service:
Replace the system board. See
board with media sensor, cable, and
spring removal" on page
Technical Support Center:
The printer will auto reset.
Service:
The printer will auto reset.
"System
4-21.
"System
4-21.
"System
4-21.
"System
4-21.