Lexmark S800 Series Service Manual page 24

Lexmark S800 Series
Error
Name
Code
010B Printhead Error
0302 NVRAM R/W
0303 Memory Failure
0304 Hardware Failure
0305 ROM_Checksum_Failure
0306 Paper System Failure
2-5
Service Manual
Description
The printhead has an error.
An error was detected in
reading or writing NVRAM.
Unable to initialize memory.
General hardware failure
(unable to localize failure to a
specific system).
Corrupted ROM.
The DC paper feed system fails
to initialize or calibrate.
Action
Technical Support Center:
Reinstall the print tanks. If the error is still
there, then replace the print tanks. Check
the printhead contacts to be sure that they
are clean.
Service:
Reinstall the print tanks. If the problem
remains, then clean the contacts on the
printhead. If the problem persists, then
replace the printhead.
Technical Support Center:
Replace the All-In-One.
Service:
Replace the system board. See
board with media sensor, cable, and
spring removal" on page
Technical Support Center:
Replace the All-In-One.
Service:
Replace the system board. See
board with media sensor, cable, and
spring removal" on page
Technical Support Center:
Replace the All-In-One.
Service:
Replace the system board. See
board with media sensor, cable, and
spring removal" on page
Technical Support Center:
Unplug the All-In-One from the wall outlet;
wait a few seconds, then plug the All-In-
One back in and turn the power on.
Service:
Replace the system board. See
board with media sensor, cable, and
spring removal" on page
Technical Support Center:
Unplug the All-In-One from the wall outlet;
wait a few seconds, then plug the All-In-
One back in and turn the power on.
Service:
Replace the system board. See
board with media sensor, cable, and
spring removal" on page
"System
4-21.
"System
4-21.
"System
4-21.
"System
4-21.
"System
4-21.