Grandstream Networks GWN7600 User Manual page 28

Note
If a GWN7600 is not being discovered or the pair icon is grey color, make sure that it is not being paired
with another GWN76xx Access Point acting as Master Controller, if yes, users will need to unpair it first, or
reset it to factory default settings in order to make it available for pairing by other GWN76xx Access Point
Controller
Access Point, this will help redirecting clients to a radio band
accordingly for efficient use and to benefit from the maximum
throughput supported by the client.

Mode: Choose the mode for the frequency band, 802.11n/g/b for
2.4 GHz and 802.11ac for 5GHz.

Channel Width: Choose the Channel Width, note that wide
channel will give better speed/throughput, and narrow channel
will have less interference. 20MHz is suggested in very high
density environment.

40MHz Channel Location: Configure the 40MHz channel
location when using 20MHz/40MHz in Channel Width, users can
set it to be Secondary below Primary, Primary below Secondary
or Auto.

Channel: Select Auto, or a specified channel, default is Auto. Note
that the proposed channels depend on Country Settings under
"System Settings–>Maintenance".

Enable Short Guard Interval: Check to activate this option to
increase throughput.

Active Spatial Streams: Choose active spatial stream if Auto, 1
or 2 streams.

Radio Power: Set the Radio Power, it can be Low, Medium or
High.

Disable Beam Forming: Check to disable beam forming to
broadcast the signal to a wide area.

Reboot Device: Reboot the access point.

Upgrade Device Firmware: Upgrade the access point's firmware
(Appearing only for Slave Access Points).
GWN7600 User Manual
P a g e | 28