Connections When Using The Speaker Input Wire - Pioneer GM-A6704 Owner's Manual

(Connecting the units )
If only one input plug is used, e.g. when the
car stereo has only one output (RCA output),
connect the plug to RCA input jack A rather
than B.
Two-channel output (Stereo} I (Mono}
• Slide INPUT SELECT (input select) switch
to 2CH position.
~IJ!M:J=
- - - - -
IPUTSELECT I,'UT SPEAKER
«t?l(@
~
r§
'""'
~~·-·
Jood®@=
1000 lO[JOOOOOO
f
~
®
CD
RCA input jack A
For two-channel output, connect the RCA
plugs to the RCA input jack A.
(g)
Connecting wire with RCA pin plugs (sold se-
parately)
®
From car stereo (RCA output)[!]
Connections when using
the speaker input wire
Connect the car stereo speaker output wires
to the amplifier using the supplied speaker
input wire.
• Do not connect both the RCA in put and the
speaker input at the same time.
En
CD
Car Stereo
(g)
Speaker output
®
White/black: CH A, Left
8
@
White: CH A, Left (±)
®
Gray/black: CH A, Right
8
®
Gray: CH A, Right(±)
(J) Green/black: CH B, Left
8
®
Green: CH B, Left(±)
®
Violet/black: CH B, Right
8
@ Violet: CH B, Right(±)
@ Speaker input connector
To speaker input terminal of this unit.
Note
If speaker input wires from a headunit are con-
nected to this amplifier, the amplifier will automa-
tically turn on when the head unit is turned on.
When the head unit is turned off, the amplifier
turns off automatically. This function may not
work with some head units. In such cases, make
sure that the CH A Left channel is connected cor-
rectly. If the function sti II does not work, please
use a system remote control wire (sold sepa-
rately). If multiple amplifiers are to be connected
together synchronously, connect the head unit
and all amplifiers via the system remote control
wire.[!]