Cisco Nexus 1000V Troubleshooting Manual page 85

Chapter 6 High Availability
MSYNC done.
Remote MSYNC not done.
Module online notification received.
Local super-state is: SYSMGR_SUPERSTATE_STABLE
Standby super-state is: SYSMGR_SUPERSTATE_STABLE
Swover Reason : SYSMGR_SUP_REMOVED_SWOVER <-- Reason for the last switchover
Total number of Switchovers: 0 <-- Number of switchovers
Message count:
Total latency:
Total exec:
When a role collision is detected, a warning is highlighted in the CLI output. Use the following command
to display the CLI output:
Example 6-6
switch# show system redundancy status
Redundancy role
---------------
administrative: secondary
operational: secondary
Redundancy mode
---------------
administrative: HA
operational: HA
This supervisor (sup-2)
-----------------------
Redundancy state: Active
Supervisor state: Active
Internal state: Active with HA standby
Other supervisor (sup-1)
------------------------
Redundancy state: Standby
Supervisor state: HA standby
Internal state: HA standby
WARNING! Conflicting sup-2(s) detected in same domain
-----------------------------------------------------
MAC Latest Collision Time
00:50:56:97:02:3b 2012-Sep-11 18:59:17
00:50:56:97:02:3c 2012-Sep-11 18:59:17
00:50:56:97:02:2f 2012-Sep-11 18:57:42
00:50:56:97:02:35 2012-Sep-11 18:57:46
00:50:56:97:02:29 2012-Sep-11 18:57:36
00:50:56:97:02:30 2012-Sep-11 18:57:42
00:50:56:97:02:36 2012-Sep-11 18:57:46
00:50:56:97:02:2a 2012-Sep-11 18:57:36
NOTE: Please run the same command on sup-1 to check for conflicting(if any) sup-1(s) in
the same domain.
If no collisions are detected, the highlighted output is not displayed.
Use the following command to display the accounting logs that are stored on a remote VSM.
OL-31593-01
>> Duration of the switchover would be listed, if any.
Statistics:
0
0
0
show system redundancy status Command
High Availability Troubleshooting Commands
Max latency:
Max exec:
Cisco Nexus 1000V Troubleshooting Guide, Release 5.2(1)SV3(1.1)
0
0
6-9