Cisco Nexus 1000V Troubleshooting Manual page 67

Chapter 5 Upgrades
Changing the HA Role
You can change the HA role of the VSM.
BEFORE YOU BEGIN
•
•
DETAILED STEPS
Go to the domain of the existing VSM.
Step 1
a.
b.
c.
Example:
switch# config t
switch(config)# svs-domain
switch(config-svs-domain)# domain id 1941
Warning: Config saved but not pushed to vCenter Server due to inactive connection!
Change the HA role.
Step 2
system redundancy role [primary | secondary | standalone]
Example:
switch(config-svs-domain)# system redundancy role secondary
Setting will be activated on next reload.
switch(config-svs-domain)#
Example:
switch(config-svs-domain)# system redundancy role primary
Setting will be activated on next reload.
switch(config-svs-domain)#
Step 3 Copy the running configuration to the startup configuration.
copy run start
Example:
switch#(config-svs-domain)# copy run start
[########################################] 100%e
switch#(config-svs-domain)#
You have completed this procedure. Return to the
Step 4
section on page
OL-31593-01
Log in to the CLI in EXEC mode.
Know the domain ID of the existing VSM.
configure terminal
svs-domain
domain id domain-id
5-12.
"Recovering a Primary VSM with Active Secondary"
Cisco Nexus 1000V Troubleshooting Guide, Release 5.2(1)SV3(1.1)
Problems with the GUI Upgrade
5-11