Cisco Nexus 1000V Troubleshooting Manual page 106

VSM and VEM Troubleshooting Commands
L2/L3 Control VLAN mode: L2
L2/L3 Control VLAN interface: mgmt0
Status: Config push to VC successful
Example 7-4
switch# show port-profile name SystemUplink
port-profile SystemUplink
description:
type: ethernet
status: enabled
capability l3control: no
pinning control-vlan: -
pinning packet-vlan: -
system vlans: 114,115
port-group: SystemUplink
max ports: 32
inherit:
config attributes:
switchport mode trunk
switchport trunk allowed vlan all
system mtu 1500
no shutdown
evaluated config attributes:
switchport mode trunk
switchport trunk allowed vlan all
no shutdown
assigned interfaces:
Example 7-5
switch# show running-config vlan 260-261
version 4.0(4)SV1(3)
vlan 260
name cp_control
vlan 261
name cp_packet
switch#
Example 7-6
~ # vem-health check
VSM Control MAC address: 00:50:56:a3:36:90
Control VLAN: 90
DPA MAC: 00:02:3d:40:5a:03
VSM heartbeats are not reaching the VEM.
Your uplink configuration is correct.
Recommended action:
Check if the VEM's upstream switch has learned the VSM's Control MAC.
Example 7-7
switch# show mac address-table interface Gi3/1 vlan 3002
Legend: * - primary entry
vlan
------+----------------+--------+-----+----------+--------------------------
Cisco Nexus 1000V Troubleshooting Guide, Release 5.2(1)SV3(1.1)
7-20
show port-profile Command
show running-configuration vlan Command
vem-health check Command
00:50:56:a3:36:90
show mac address-table interface Command
age - seconds since last seen
n/a - not available
mac address type learn age
Chapter 7 VSM and VEM Modules
ports
OL-31593-01