Transferring Work And Construction; Transfer Of Installation; Place For Installation; Regarding Electric Work - Acson ART 55 A Technical Manual

1.5 When The Air Conditioner Is Not To Be Used For A Long Time
If the air conditioner is not to be used for a long time due to seasonal change, etc.,
Please do the following work.
1. The power supply switch is turned off.
If the power supply is kept on, several watts or several tends of watts will be wasted.
The accumulation of dust, etc., can result in fire.
2. Filter, and drain pan must be cleaned. Pay attention to clean dust in the drain.
3. Run it for 4-5 hours with the air blowing until the inside is completely dry.
Failing to do so can result in the growth of unhygienic, unhealthy mold in scattered areas throughout
the room.
1.6 In Case Of Failure
(1) Never remodel the air conditioner by yourself. Consult your dealer for any repair service.
Improper repair work can result in water leakage, electric shock, fire, etc.
(2) If the power breaker is frequently activated, get in touch with your dealer.
Leaving the unit as it is under such conditions can result in fire or failure.
(3) If refrigerant gas blows out or leaks, stop the operation of the air conditioner.
Thoroughly ventilate the room, and contact your dealer.
Leaving the unit as it is can result in accidents due to oxygen deficiency.

2. Transferring Work And Construction

2.1

Transfer Of Installation

(1) When removing and reinstalling the air conditioner, consult with your dealer in advance to
ascertain the cost of the professional engineering work required for transferring the installation.
(2) Please do not use refrigerant other than the specified refrigerant when you top-up/recharge the
refrigerant at the new installation site .
(3) When moving or reinstalling the air conditioner, consult with your dealer.
Defective installation can result in electric shock, fire, etc.
2.2

Place For Installation

Please do not use the unit in the following places.
(1) Places with a lot of oil, moisture, and dust.
(2) Places with high salinities such as seaside.
(3) Places where sulfur gas, volatile gas, and corroded gas are filled.
(4) Places where acid solution is frequently used.
(5) Places where special spray is frequently used.
(6) Hot spring zones.
(7) Near to machines that generate high cycles (High cycle welding machine etc.).
(8) Places where ventilation entrance of unit is closed by snowfall.
(9) The unit must be installed on stable, level surface.
The consequence of using a unit in the places mentioned above is the main body might corrode,
the refrigerant might leak, the performance of the unit might decrease remarkably, and it might
cause damage of parts in the unit.
2.3

Regarding Electric Work

(1) The electrical work must be undertaken by a person who is qualified as an electrical technician
with respect to local governing laws.
(2) Please install the earth connection for the electric shock prevention.
(3) Never connect the grounding wire to a gas pipe, water pipe, arrestor, or telephone grounding
wires. For details, consult with your dealer.
(4) In some types of installation sites, the installation of an earth leakage breaker is mandatory.
For details, consult with your dealer.
(5) The breaker and the fuse must be of correct capacity.
171