Table of Contents
Advertisement
Modemulator Commands
Modemulator commands will not be forwarded to the analog modem.
{$ * Display Modemulator Command Help Screen:
AT{$
Modemulator Command Help (unrecognized commands accepted & ignored)
{B
Program Security Banner
{B?
Display Security Banner
{L
Program Login Banner
{L?
Display Login Banner
{S
Display Security Settings
{Sn= Set User n Password
{Pn= Set User n Admin Privileges {Fn S59.2 Disable Cmd Fwd to Analog Port
{W
Wipe
Phone:Port:IP Recs
{X
Display Phone:Port:IP Recs
{Y=
Program Phone:Port:IP Recs
OK
{A
Switch to Analog Modem Port until DTR Off
This must be the last command in the AT command string.
If an analog modem is attached to the analog modem port, you can communicate directly with it
by using this command. When finished, toggle DTR off then back on to return to AT command
mode in the Modemulator.
{B * Program Security Banner
This must be the last command in the AT command string.
When Password Prompting is enabled (see
characters) can be displayed before the Login Banner and login prompt.
Factory default is no Security Banner.
Modemulator User Guide
{A
Switch to Analog Port until DTR off
{I= Program CID
{Z= Program Listener Port Number
Bitmapped: n=1 Shown Below
--------------------------
{Cn S59.1 Enable CID
{Mn S59.3 Single-Ended Modemulation
{Rn S59.4 Sched Remote Cmd Mode Next Dial
{On S59.5 Originate Only
{Jn S59.6 Concatenate Banners
{Dn S59.7 Enable Dialback Security
{Sn
command), a Security Banner (up to 256
Page 50 of 113
Advertisement
Table of Contents
