Adjustment; Parts Change Of Notes; Adjustment Required When The Set Is Repaired Or Replaced - Pioneer PDP-6071PU Service Manual

1

7. ADJUSTMENT

7.1 PARTS CHANGE OF NOTES

A
1. At shipment, the unit is adjusted to its best conditions. Normally, it is not necessary to readjust even if an assembly is replaced. If the
adjustment is shifted or if it becomes necessary to readjust because of part replacement, etc., perform the adjustment as described below.
2. Any value changed in Service/Factory mode will be stored in memory as soon as it is changed. Before readjustment, take note of the
original values for reference in case you need to restore the original settings.
3. Use a stable AC power supply.

7.2 ADJUSTMENT REQUIRED WHEN THE SET IS REPAIRED OR REPLACED

When any of the following assemblies is replaced
B
POWER SUPPLY Unit
60 DIGITAL Assy
60 X DRIVE Assy
C
60 Y DRIVE Assy
607 SCAN A Assy
607 SCAN B Assy
Service Panel Assy
D
MAIN Assy (*)
SENSOR Assy
TANSHI Assy
E
(*) : When replacing the MAIN Assy, be sure to do the FINAL SETUP.
F
116
1
2
Note: Checking the Cable Card ID
The PDP has a slot for a cable card that is used for managing your
information by the cable TV company. The following procedure
allows you to check your Cable Card ID and the Host ID.
1.
Press HOME MENU.
2.
Select "Tuner Setup". (
3.
Select "Channel Setup". (
4.
Select "POD ID". (
• The Host ID and Cable Card ID appear.
5. Press HOME MENU to exit the menu.
PDP-6071PU
2
3
Refer to "7.7 HOW TO CLEAR HISTORY DATA" and
"7.8 PROCEDURE WHEN REPLACING THE POWER
SUPPLY UNIT".
Writing of backup data is required.
Refer to the "7.4 BACKUP WHEN THE PANEL UNIT
IS ADJUSTED. "
No adjustment required
No adjustment required
No adjustment required
No adjustment required
Refer to "7.5 ADJUSTMENTS WHEN THE SERVICE
PANEL ASSY IS REPLACED" and "7.7 HOW TO
CLEAR HISTORY DATA".
No adjustment required
Writing of backup data is required.
Refer to the "7.4 BACKUP WHEN THE PANEL UNIT
IS ADJUSTED. "
No adjustment required
/ then ENTER)
/ then ENTER)
/ )
3
4
4