Edje-2000
Connecting to the Edje-2000 Via Ethernet
Adtec Digital, Inc. USA
The Connections Status Bar will change as show below.
1. Default state, not connected. The same prompt is displayed
when a connection error occurs.
2. While attempting to connect.
3. Once connected.
The Edje-2000 ships with the following factor Ethernet configuration.
Variable
IP address
IP Mask Sub Net Mask
Gateway IP
User Name
Password
It is unlikely that the local network will be in the 192.168.10.xxx address
range. Therefore a serial connection will be required to configure the
Edje-2000 for the local network. A serial connection must be made then
the Ethernet Variables can be modified in the edje GUI.
IP Configuration Tab
Real Time MPEG 2 Streaming Encoder
Setting
192.168.10.48
255.255.255.0
0.0.0.0 Defaulted off.
ADTEC
NONE
Version 1.3
Page 36 of 36