Yaesu FT-891 Advance Manual page 18

CW Mode Operation
Text Message Programming from the FT-891 Control Panel
1. Set the operating mode to CW.
2. Press the [ F ] key repeatedly, to find the
"REC SETTING" list screen.
NOTE: This screen may be enabled/
disabled via Menu Mode "05-11
[ REC SETTING ] ".
3. Rotate the MULTI function knob to select
"MEM".
4. Press the MULTI function knob. A blinking
"REC" icon will appear in the display.
5. Rotate the MULTI function knob to select
any channel [ CH1 ] through [ CH5 ] .
6. Press the MULTI function knob. The "CW
TEXT" screen will appear.
7. Press the [ B ]( EDT ) key. The text input
screen will appear.
8. Rotate the MULTI function knob to select the letters, numbers, or symbols of the de-
sired label, then press the MULTI function knob.
9. Press the MULTI function knob.
10. Repeat step 8 and 9 to program the remaining letters, numbers, or symbols of the
desired text. Up to 50 characters may be stored in each of the five memories.
r Rotate the MULTI function knob to set the cursor position and press the [ B ]( CE )
key to erase and input characters.
11. When text entry is complete, press the [ C ]( ENT ) key.
12. Press the [ A ]( BCK ) key to exit the text input screen.
13. Press and hold the [ F ] key for one second to exit the "REC SETTING" list screen and
resume normal operation.
18 FT-891 Advance Manual