Page 2
Yaesu website (http://www.yaesu.com). the full operating potential of this system. The FT-891 transceiver has a built-in USB to Dual UART Bridge, allowing direct connection from the rear-panel USB jack to the USB jack of your computer without the need of any external boxes.
Page 3
Tables” to configure the appropriate parame- Command Parameter Terminator ters. There are three commands for the FT-891 as When configuring parameters, be careful not to shown below: make the following mistakes. Set command: Set a particular condition For example, (to the FT-891) when the correct parameter is “IS0+1000”...
Page 4
MEMORY READ METER SW MEMORY WRITE & TAG MEMORY WRITE MOX SET NARROW NOISE BLANKER NOISE BLANKER LEVEL NOISE REDUCTION OPPOSITE BAND NFORMATION OFFSET (Repeater Shift) PRE-AMP (IPO) PLAY BACK POWER CONTROL SPEECH PROCESSOR LEVEL FT-891 CAT Operation Reference Book...
Page 5
VFO-B TO VFO-A Read Answer AUTO NOTCH P1 0: ( Fixed ) P1 P2 P2 0: Auto Notch “OFF” 1: Auto Notch “ON” Read Answer P1 P2 BAND DOWN P1 0: ( Fixed ) Read Answer FT-891 CAT Operation Reference Book...
Page 19
P1 P1 P1 Read Answer P1 P1 P1 VFO-A TO MEMORY CHANNEL Read Answer VOX STATUS P1 0: VOX “OFF” 1: VOX “ON” Read Answer ZERO IN ( CW AUTO ZERO IN Function ) Read Answer FT-891 CAT Operation Reference Book...
Page 20
Copyright 2017 YAESU MUSEN CO., LTD. All rights reserved. No portion of this manual may be reproduced without the permission of YAESU MUSEN CO., LTD. YAESU MUSEN CO., LTD. Tennozu Parkside Building 2-5-8 Higashi-Shinagawa, Shinagawa-ku, Tokyo 140-0002 Japan YAESU USA 6125 Phyllis Drive, Cypress, CA 90630, U.S.A.