Cleaning The Body Of The Appliance; Cleaning The Water Tank, Water Tray And Nanocloud Rotary Humidification Wick; Cleaning The Pre-Filter - Philips HU5930 User Manual

Cleaning the body of the
appliance
Regularly clean the inside and outside
of the appliance to prevent dust from
collecting.
1
Wipe away dust with a soft dry cloth
from the body of the appliance.
2
Clean the air outlet with a soft dry
cloth.
Cleaning the water
tank, water tray and
NanoCloud rotary
humidification wick
Note
•
Cleaning the water tank, water
tray and NanoCloud rotary
humidification wick every week to
keep them hygienic.
1
Pull out the water tank (fig. h).
2
Pull out the water tray (fig. }).
3
Take the wick wheel off the wick
support (fig. ~).
4
Rinse the water tank, water tray and
NanoCloud rotary humidification
wick under a running tap.
Note
•
Do not take the NanoCloud rotary
humidification wick off the wheel
during cleaning.
•
Do not scrub the NanoCloud rotary
humidification wick or place it under
direct sunlight.
•
If necessary, use a mild detergent to
clean the water tank and water tray.
In this case, rinse the water tank and
water tray thoroughly.
10 EN
5
Wipe the outside of the water tank
and water tray dry.
6
Place the wick wheel on the wick
support (fig. k).
Note
•
When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
7
Place the water tray back into the
appliance (fig. l).
8
Place the water tank back into the
appliance (fig. p).

Cleaning the pre-filter

Filter alert light
status
Cleaning light
goes on (fig. )
Note
•
Only the pre-filter and NanoCloud
rotary humidification wick are
washable. The NanoProtect filter is
not washable.
1
Pull the top part of the back panel
towards you to release it from the
appliance (fig. c).
2
To remove the pre-filter, press the
two clips down and pull the filter
towards you (fig. €).
3
Wash the pre-filter under a running
tap. If the pre-filter is very dirty, use
a soft brush to brush away the dust
(fig. ).
4
Air dry the pre-filter.
Follow this
Clean the pre-
filter