Note
•
Make sure that the pre-filter is
completely dry. If it is still wet,
bacteria may multiply in it and
shorten the lifetime of the pre-filter.
5
After the pre-filter is completely dry,
place it back into the back panel
(fig. ‚).
6
Touch and hold the reset button
for 3 seconds to reset the pre-filter
cleaning time (fig. ƒ).
Descaling the
NanoCloud rotary
humidification wick
Filter alert light
status
Cleaning light
goes on (fig. )
1
Pull out the water tank (fig. h).
2
Pull out the water tray (fig. }).
3
Take the wick wheel off the wick
support (fig. ~).
4
Mix the white vinegar with an equal
amount of tap water in a container
that is large enough to soak the
NanoCloud rotary humidification
wick in.
Follow this
Descale the
NanoCloud
rotary
humidification
wick
Note
•
White vinegar has 5% acetic acid.
•
If there are white deposits
(limescale) on the filter, make sure
that the side with the white deposits
is immersed in the water.
•
Do not take the NanoCloud rotary
humidification wick off the wheel
during descaling.
5
Let the NanoCloud rotary
humidification wick soak in the
solution for one hour (fig. „).
6
Rinse the NanoCloud rotary
humidification wick under the tap to
rinse away vinegar residues. During
rinsing, turn the wick so that both
front and back are rinsed (fig. ...).
7
Air dry the NanoCloud rotary
humidification wick.
Note
•
Do not put the NanoCloud rotary
humidification wick under direct
sunlight.
8
Touch and hold the reset button
for 3 seconds to reset the
NanoCloud rotary humidification
wick cleaning time (fig. ƒ).
EN
11