Saeco Aulika Sup 040R Service Manual page 19

AULIKA
WATER MENU
This menu can be used to set the parameters for the correct management of water used to brew
WATER MENU
coffee.
HARDNESS
WATER SUPPLY
SYSTEM (MAINS)
OFF
ON
Particular attention must be paid to this function, as malfunctions can occur in case
the wrong values are input The "ON" option can be enabled only if the "Mains Water " kit is installed, and
only if it is correctly connected; in all other cases, the option causes a malfunction. When the "ON" option
is selected, the "FILTER ENABLING" and "FILTER ACTIVATION" functions shall be hidden and it will not be
possible to select them.
FILTER ENABL.
Functions available only
if the "WATER MAINS"
function is set on OFF.
FILTER ACTIV.
MAINTENANCE
This function is used to set all the functions for the correct management of the machine maintenance
MAINTENANCE
ASSEMBLY CLEANING
DESCALING
START
SIGNAL
OFF
ON
CAPPUCCINATORE
CLEANING
FACTORY SETTINGS
This function makes it possible to reset the default parameters.
FACT. SETTINGS
Note: this section describes how to reset the default values for the custom settings of the
machine menu.
To change the water hardness setting of the machine. Thanks to the "Hardness" function, it is possible
to adapt the machine to the level of hardness of the water used, so that the machine can signal the
need for a descaling cycle at the correct time.
To activate the function that allows the machine to be connected to the water mains.
(only for specific models).
In this way, the machine shall operate using only its installed tank.
In this way, the machine shall operate using water from the main water supply system
To enable/disable the signal for the replacement of the water filter. When this function is active, the
machine warns the user when the water filter needs to be replaced.
OFF: Signal disabled
ON: Signal enabled (this value is set automatically when the filter is activated).
To activate the filter after its installation or replacement
This function makes it possible to perform the Brewing Unit washing cycle
This function makes it possible to perform the descaling cycle
This function makes it possible to start the descaling cycle as show in the relevant paragraph
This function makes it possible to activate the display signals when the machine requires a
descaling cycle
In this way the signalling function is disabled
In this way the signalling function is enabled; a message shall be displayed when the machine
requires a descaling cycle
This function makes it possible to perform the cleaning cycle of the cappuccinatore used to prepare
milk beverages.
Note: this cleaning is important for the correct maintenance and operation of the
cappuccinatore and/or thermos.
Rev. 00 / July 2012
03 USER GUIDE
Page / 07
06