Saeco Aulika Sup 040R Service Manual page 17

AULIKA
BEVERAGE PARAMETERS
This paragraph describes the various parameters that can be changes.
Note: not all parameters are present for all programmable items.
PRE-INFUSION
MILK QUANTITY
COFFEE TEMPERATURE
WATER QUANTITY
COFFEE LENGTH
DEFAULT
Pre-infusion: coffee is wet before infusion, so as to highlight the full aroma of coffee, with excellent
results. OFF: pre-infusion does not occur.
LOW: enabled HIGH: longer, to enhance the taste of coffee.
This section can be used to program the quantity of milk delivered every time the beverage is selected.
The bar makes it possible to fine-tune the quantity of milk to be used (unit of measure in seconds)
These settings are valid only to program the delivery of beverages containing milk.
This section can be ised to program the coffee brewing temperature.
LOW: low temperature
NORMAL: standard temperature
HIGH: high temperature
This section can be used to program the quantity of water delivered every time the relevant key is
pressed. The bar makes it possible to fine-tune the quantity of water to be used (unit of measure in
turbine pulses).
These settings are valid only to program the delivery of Hot water.
This section can be used to program the quantity of coffee delivered every time the beverage is
selected. The bar makes it possible to fine-tune the quantity of coffee to be used (unit of measure in
turbine pulses)
For every beverage, it is possible to go back to the default settings, also according to the language
selected.
Once this function is selected, the customised settings for that beverage are deleted.
Rev. 00 / July 2012
03 USER GUIDE
Page 04 / 07