User Guide; Machine Warnings - Saeco Aulika Sup 040R Service Manual

AULIKA
3.1.

Machine warnings

CHIUDERE LO
In order for the machine to
SPORTELLO
operate, close the service door
LATERALE
INSERIRE VASCA
Insert drip tray
RACCOGLIGOCCE
INSERIRE
Insert grounds drawer
CONTENITORE FONDI
Close or position correctly the
INSERIRE
coffee beans container lid in or-
COPERCHIO CHICCI
der for the machine to dispen-
se any beverage.
RIEMPIRE
Extract the tank and fill it with
SERBATOIO ACQUA
fresh drinking water
Place the brewing unit in its
INSERIRE GRUPPO
seat.
The selected operation requi-
res the delivery of milk.
INSERIRE IL
Place the cappuccinatore on
CAPPUCCINATORE
the machine as shown in the
manual.
The selected operation requires
the delivery of milk.
INSERIRE LA VALVOLA
Insert the previously removed
NEL CAPPUCCINATORE
valve back in the cappuccinato-
re, as specified in the manual.
Fill the coffee contained with
AGGIUNGERE CAFFE'
beans.
If this message is displayed
after starting the machine, this
DECALCIFICAZIONE
means that a descaling cycle
DECALCIFICAZIONE
needs to be performed.
NECESSARIA.
ESEGUIRE? Contact the operator.
Please remember that damage
caused by no descaling is not
covered by the warranty.
SVUOTARE
CONTENITORE FONDI
RIAVVIARE
PER RISOLVERE
IL PROBLEMA
Rev. 00 / July 2012
03 USER GUIDE
The machine requests a descaling cycle.
When this message appears, the machi-
ne can be used but its performance can
be compromised.
Please remember that damage caused
by no descaling is not covered by the
warranty.
The machine asks for the replacement
of the "Intenza" water filter.
Please replace the filter.
This alarm is displayed only if the "Ena-
ble Filter" function is ON.
The machine signals that in a few
cycles the grounds drawer shall need to
be emptied.
It is still possible to deliver some pro-
ducts.
Remove the grounds drawer and empty
the grounds into an appropriate con-
tainer. Note: the grounds drawer must
be emptied only when the machine
requests it and with the machine on.
If the drawer is emptied while the ma-
chine is off, the machine cannot record
this operation.
Blinking red led Machine in Stand-By.
It is possible to modify the Stand-By
settings (please contact the operator).
An event that requires the machine
to be restarted has occurred.
Please note down the code (E xx)
displayed at the bottom.
Turn the machine off and turn it back
on again after 30 seconds. If the pro-
blem persists, call the service centre.
Page 01 / 07