Compressor Assembly; Setting Up; Maximum Permissible Inclination D - GEA FK50/460 N Assembly Instructions Manual

4| Compressor assembly

INFO!

4.1 Setting up

WARNING! Move compressors only with hoists that have adequate load-bearing
Transport and suspension unit on both eyebolts (Fig. 8).
Fig. 8
Fittings (e.g. pipe holders, additional units etc.) on the compressor are permissible only
following consultation with GEA.
Setup on an even surface or frame with sufficient load-bearing capacity. Use all 4 fastening
points.
Correct setup of the compressor and mounting of the belt drive are decisive for running comfort,
operating safety and the service life of the compressor.
4.2 Maximum permissible inclination
ATTENTION! Poor lubrication can damage the compressor. Respect the stated
A
a
Fig. 9
New compressors are factory-filled with inert gas (3 bar nitrogen).
Leave this service charge in the compressor for as long as possible
and prevent the ingress of air.
Check the compressor for transport damage before
starting any work.
capacity.
values.
A
a
A A
a a
max. 30°,
A
max. 2 minutes
max. 15°,
a
continuous
operation
D
GB
F
I
TR
CN
11