Routing With The Sz-Of 1000 Beam Compasses; Copy Cutting - Festool OF 1010 EQ Instruction Manual

11.1
12.1
13.6
13.5
13.4
13.3 13.2 13.1
the underside of the router table is parallel to the
surface of the workpiece.
When working with marking-up lines, the marks on
the platen (10.6) and the scale on the support (10.7)
show the centre axis of the cutter.
Routing with the SZ-OF
1000 beam compasses
With the SZ-OF 1000 beam compasses (accessory)
you can make circular cuts or segments of circles
with diameters from 153 to 760 mm.
- The beam compasses are pushed into the front
groove of the platen until the desired radius is set.
- Lock the beam compasses with the rotating knob
(11.1).
Practical hint: To prevent the tip of the compasses
from making a hole in the workpiece, fi x a thin
board at the centre point by means of double-sided
adhesive tape.
A copying ring or the copying device is used to ex-
actly reproduce existing workpieces (both available
as accessories).
a) Copying ring
12.2
- Fasten the copying rings (12.2) to the platen in-
stead of the cover ring (12.1) from below.
When choosing the size of the copying
ring (12.2) make sure that the cutter used (12.3) fi ts
12.3
through the ring's opening.
The distance Y between the workpiece and template
is calculated by:
Y = 1/2 (Ø copying ring - Ø cutter) / 2
The copying ring can be centred exactly with the
centring cone ZF-OF (Order No. 486035)
b) Copying device
The angle arm WA-OF (13.3) and copier scanning
set KT-OF, consisting of roller holder (13.2) and
three copying rollers (13.1), are required for the
copying device.
- Screw the angle arm at the desired height in the
platen's threaded bore (13.7) with the rotating
knob (13.6).
- Fit a copying roller in the roller holder and bolt
this to the angle arm with the rotating knob (13.4).
Make sure that the copying roller and cutter have
the same diameter!
- Turn the adjusting wheel (13.5) to adjust the
distance between the copying roller and cutter
axis.
11

Copy cutting