Reconfiguring Forward Signal Routing - Cisco GS7000 Installation And Operation Manual

Reconfiguring Forward Signal Routing

Introduction
This section describes how to configure the forward signal routing of the 1.2 GHz
GS7000 Node.
Forward Routing Configurations
The receiver modules and the forward configuration module determine the forward
signal routing. Each module must be in its proper slot to achieve the different node
configurations.
The following table shows the required modules and their slot locations for various
node configurations.
If the configuration is...
one receiver, four outputs
one receiver, four outputs
(with external RF source)
two receivers, four outputs,
redundant
two receivers, four outputs,
redundant (with external
RF source)
two receivers, each feeding
two outputs, 2-way
segmented
four receivers, each pair
feeding two outputs, 2-way
segmented, redundant
three receivers, four
outputs
three receivers, four
outputs
Then use configuration module...
1x4 Forward
1x4 Forward with Forward RF
Injection, plus FLI module
1x4 Redundant Forward, plus
SM/LCM
1x4 Redundant Forward with Forward
RF Injection, plus SM/LCM and FLI
module
2x4 Forward
2x4 Redundant Forward, plus
SM/LCM
3x4 Forward (for receivers 1, 3, and 4)
3x4 Forward (for receivers 1, 2, and 4)

Reconfiguring Forward Signal Routing

Install Receivers in
Positions...
1
1
1, 2
1, 2
1, 3
1, 2, 3, 4
1, 3, 4
1, 2, 4
103