Wiring Plan, Single Chamber Housing - Vega VEGASWING 61 Operating Instructions Manual

Housing overview
VEGASWING 61 - - transistor (NPN/PNP)
3 Remove approx. 10 cm (4 in) of the cable mantle, strip
approx. 1 cm (0.4 in) insulation from the ends of the
individual wires
4 Insert the cable into the sensor through the cable entry
5 Open the terminals with a screwdriver
6 Insert the wire ends into the open terminals according to
the wiring plan
7 Tighten the terminals with a screwdriver
8 Check the hold of the wires in the terminals by lightly
pulling on them
9 Tighten the compression nut of the cable entry. The seal
ring must completely encircle the cable
10 Screw the housing cover back on
The electrical connection is finished.

5.3 Wiring plan, single chamber housing

The following illustrations apply to the non-Ex as well as to the
EEx d version.
4
1
Fig. 8: Material versions, single chamber housing
1
Plastic (not with EEx d)
2
Aluminium
3
Stainless steel (not with EEx d)
4 Filter element for pressure compensation or blind stopper with version IP 66/
IP 68, 1 bar (not with EEx d)
Connecting to power supply
4
2
4
3
17