Pyramid WM-1000 Product Manual page 24

Base Config:
Mobile Interface Protocol: Determines the serial protocol (if any) used to communicate with the mobile radio.
Kenwood Base ID: In Kenwood NEXEDGE and FleetSync mode, this sets the ID of the base radio for messag-
ing.
Mobile Audio Preset: Sets default PTB and BTP audio as well as common data polarities for the radio interface
Local Mic Audio Gain: Sets the audio gain used for Local Mic Repeat.
PTB Audio Gain: Sets the audio gain of audio sent to the mobile radio interface (heard by the dispatcher).
BTP Fine Audio Gain: Sets the audio gain of audio sent WM-1000 handheld user.
BTP Coarse Audio Gain: Sets the audio gain of audio sent WM-1000 handheld user.
Priority Wait: Sets the revert time used when resuming priority when there is no traffic being handled.
Note: You can adjust any parameter and WRITE to a unit, even if the unit is handling a call. For example, if you
change a audio level or filter, you can make the change and hear the result real-time by writing to the unit and
listening to the audio through the WB-1000.
Note: Any WM-1000 specific parameter requires you to PAIR the WM-1000 with this WB-1000 base after you
write data to the base. It is always a good idea to PAIR after programming the WB-1000 with updated data.