Pyramid WM-1000 Product Manual page 23

Common Data:
Rmt En Polarity: Determines if the Remote Enable input from the mobile is active high or low.
COR Polarity: Determines if the COR signal from the mobile is active high or low.
On-Air Polarity: Determines if the Tx indication from the mobile is active high or low.
Mobile Type: Select either Conventional, Trunking. If Trunking is selected, the WB-1000 will go through the voice
channel acquisition procedure during portable-to-base repeat mode.
Tx Audio: If the mobile Tx audio from the WB-1000 to the mobile is connected after pre-emphasis, select Flat
response. If connected before pre-emphasis or to the mic input, select De-Emp.
Rx Audio: If the Rx audio from the mobile to the WB-1000 is connected to the discriminator or before
de-emphasis, select Flat response. If connected after de-emphasis, select Pre-Emp.
Local Mic Repeat: Enables or disables the local mic repeat function; if enabled, ensure the on-air polarity is set
correctly and the Grey wire is configured correctly (see page 15). Not all mobile radios suport this function. Refer
to the specific appliation note for your installation for more details.
Out of Range Alert: Enables or disables the warning beep heard on the WM-1000 handheld when it goes out of
range from the WB-1000 base.
Locate Wireless Mic button: Enables or disables button on the WB-1000 used to find microphones that are lost or
misplaced within range of the WB-1000. Note: WM-1000 must be out of the cradle for this feature to work.
Silent Emergency: Set's a "Silent Emergency" mode, where if a unit presses their emergency button, their unit will
not alarm audibly, creating a discreet emergency signal from the WM-1000 to the WB-1000.