Programming & Alignment - Pyramid WM-1000 Product Manual

4.4 Programming and Alignment:
To set the audio level through the WB-1000 and the mobile radio, the connect the CPS software to the WB-1000.
The CPS software is preset with most common audio level values for your mobile radio.
Select your mobile radio model from the "Mobile Audio Preset" drop down menu. This will set the PTB and BTP
audio levels to match your mobile radio audio gain settings. This preset will also setup the polarities for Remote
Enable, COR and On-Air Detect as well as audio filtering to match the mobile radio accessory connector.
Use the drop down menu and Connect button to establish a connection to the WB-1000. Use the Read and Write
buttons to get and send data to the WB-1000.
Ensure that the WB-1000 VCP Serial Driver (provided on the USB Disk with the CPS software and in the Program
Files\WM-1000 CPS Folder) has been installed along with the CPS software AFTER you connect a WB-1000 to the
PC. A restart may be required to complete the driver installation.
Wireless Settings:
Base Alias: 15 character name for this base unit. This is displayed on the screen of the WM-1000 as the ID of the
base.
Band: Select the frequency band used by this WB-1000. There are four band choices.
RF Address: Select the RF Address to create private talk paths between the WB-1000 and WM-1000 users.