Table of Contents
Advertisement
Level 03c, May 2011
On the z10 BC, the install team must connect the Ethernet adapters for any
HMC(s) into an Ethernet switch. This switch can then be connected to J01
and J02 on the Bulk Power Hubs. (See the illustration below).
This configuration is required since the SEs have no external connection to
the HMCs, and communicate only through the Bulk Power Hubs.
Notes:
1. Only Ethernet switches can connect to the customer ports J01 and J02 on the
2. Never connect an HMC directly to J01 and J02 on the Bulk Power Hubs.
3. Never connect customer LANs to any ports other than J01 and J02 on the Bulk
4. Customer LAN 1 should be plugged into J02 on the Bulk Power Hubs.
The following illustration provides general z10 BC Ethernet cabling information and
is not intended to illustrate connection to a particular network.
Bulk Power Hubs.
Power Hubs.
Customer LAN 2 should be plugged into J01 on the Bulk Power Hubs.
"A" Side BPH
Additional Customer
LAN Network
Switch
1X
2X
3X
4X
5X
6X
7X
8X
9X
10X 11X 12X 13X 14X 15X 16X
~
~
~
Switch
1X
2X
3X
4X
5X
6X
7X
8X
9X
10X 11X 12X 13X 14X 15X 16X
~
~
~
~
~
"B" Side BPH
Chapter 6. Hardware Management Console and support element communications
J01
J02
2098 Support Element Consoles
Switch
1X
2X
3X
4X
5X
6X
9X
10X 11X 12X 13X 14X 15X 16X
2098 Hardware Management Consoles
Switch
1X
2X
3X
4X
5X
6X
9X
10X 11X 12X 13X 14X 15X 16X
Other server Support Elements
J01
J02
7X
8X
7X
8X
53
Advertisement
Table of Contents
