Casio XJ-UT331X User Manual page 34

Use this menu item:
Screen Settings 3
Projection Mode
Screen Settings 3
Ceiling Mount
Screen Settings 3
No Signal Screen
Screen Settings 3
Blank Screen
Screen Settings 3
Digital Screen Shift
Screen Settings 3
Restore Menu Defaults
Input Settings 3
COMPUTER1 Terminal/
COMPUTER2 Terminal (RC)
Input Settings 3
RGB1 Level Adjust/RGB2
Level Adjust (R)
Input Settings 3
Video Signal (V)
Input Settings 3
S-Video Signal (V)
Input Settings 3
Signal Name Indicator
Input Settings 3
Restore Menu Defaults
To do this:
Specify whether projection will be from the front of the screen or the back of the
screen.
Front*: Select this option to project from the front of the screen.
Rear: Select this option to project from the back of the screen. This setting flips the
front projected image horizontally.
Set up the projector to be positioned upside down for mounting on a wall.
On: Select when the projector is positioned upside down for mounting on a wall.
Since the bottom of the projector is upwards, the projected image is flipped
both horizontally and vertically.
Off*: Select when the projector is used on a desktop. This projects the image
assuming that the top of the projector is upwards.
Select one of the following as the projection image whenever there is no input signal
being input to the projector: "Blue"* (blue screen), "Black" (black screen), "Logo"
(projector built-in logo, or user logo, page 52), "Test Pattern". Also note that
selecting "Test Pattern" for this item will cause Auto Power Off to be disabled while a
test pattern is being projected when there is no signal.
Select one of the following as the projection image whenever the [BLANK] key is
pressed: "Blue"* (blue screen), "Black" (black screen), "Logo" (projector built-in
logo, or user logo, page 52), "Test Pattern".
See "Digital Screen Shift" (page 28).
Return all of the items in the "Screen Settings" main menu to their initial defaults for
the currently projecting image source.
Specify the method to be used to identify the COMPUTER IN 1/COMPUTER IN 2
terminal input signal.
Auto*: Projector automatically identifies the COMPUTER IN 1/COMPUTER IN 2
terminal input signal.
RGB: Always assumes the COMPUTER IN 1/COMPUTER IN 2 terminal input signal
is an RGB signal.
Component: Always assumes the COMPUTER IN 1/COMPUTER IN 2 terminal input
signal is a component video signal.
"RGB1 Level Adjust" corresponds to the RGB signal output from the COMPUTER
IN 1 terminal, while "RGB2 Level Adjust" corresponds to the RGB signal output from
the COMPUTER IN 2 terminal. Specifies whether level adjustment of the input RGB
signal is enabled (On*) or disabled (Off). Leaving this setting "On" will normally
optimize the projected image. However, depending on the input signal, there may be
cases when this setting does not optimize the image and may even distort it. If this
happens, change this setting to "Off".
Specify the method to be used to identify the VIDEO terminal input signal.
Auto*: Projector automatically identifies the video input signal.
NTSC, NTSC4.43, PAL, PAL-M, PAL-N, PAL60, SECAM:
Always assumes the video input signal is the specified video signal type.
Specify whether the newly selected input signal type should be displayed (On*) or
not displayed (Off) when the [INPUT] key is pressed to change the input signal.
Return all of the items in the "Input Settings" main menu to their initial defaults for the
currently projecting image source.
34