Table of Contents
Advertisement
Remote Controller
Projector operations are performed using the remote controller that comes with it. Point the remote
controller signal emitter at one of the signal receivers on the projector as you perform remote
controller key operations. The maximum range of the remote controller signal is approximately
5 meters (16.4 feet) (between signal emitter and receiver).
Important!
To avoid running down the batteries, store the remote control unit so its keys are not pressed
inadvertently.
Remote control signal emitter
Turns power on or off.
Press to exit the currently displayed menu or to cancel an
operation.
Keys used to set the remote control ID. See "Configuring
Remote Control ID and Projector ID Settings" (page 30).
Use the cursor keys ([][][][]) to move between menu
items, and to change setting values. Press the [ENTER] key to
select a menu item or to execute a function.
Press each of these keys to execute their functions. For
information about the function of each key, see "Basic Image
and Audio Operations During Projection" (page 24), "Using the
Presentation Timer (TIMER)" (page 30), and "Using the Setup
Menu (MENU)" (page 32).
These keys are used with network models only. They are
mainly used for File Viewer (page 39) projection operations.
23
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
