Updating Firmware And Transferring A User Logo; Mounting The Projector On A Wall - Casio XJ-UT331X User Manual

Updating Firmware and Transferring a User Logo

You can perform a procedure on a computer to update the projector's firmware (software in the
projector flash ROM). You can also transfer images to the projector to be used as a user logo.
To do this:
Update projector firmware
Transfer a user logo to the
projector

Mounting the Projector on a Wall

You can use special wall mounting hardware to mount the projector on a wall. In this configuration, the
projector should be mounted with the top of the projector downwards.
For full details, contact the retailer where you purchased the projector.
Important!
 When mounting the projector on a wall, make sure that it is at least one meter away from fire
detectors, fire alarms, and other fire protection devices. Locating the projector too close to a
fire protection device creates the risk of mis-operation of the device due to warm air
exhausted from the projector. Also, avoid locating the projector close to fluorescent lights or
other strong light sources. Bright light can shorten the operating range of the remote controller
or even make remote control impossible. When selecting a location for the projector, be sure
to test for proper operation of the remote controller.
 The vertical and horizontal orientation of the projected image is reversed from normal when
the projector is positioned upside down for mounting on a wall. You need to change the setup
of the projector in order to correct for this. For details, see "Screen Settings 3 Ceiling Mount"
(page 34) under "Setup Menu Settings".
Perform this operation:
1. Use a commercially available USB cable to connect the projector's LOGO port to
your computer's USB port.
2. Visit the CASIO website, refer to the "Projector Firmware Update Guide", and
perform the required operation to update.
1. Use a commercially available USB cable to connect the projector's LOGO port to
your computer's USB port.
2. Visit the CASIO website, refer to the "User Logo Transfer Guide", and perform the
required operation to update.
52